06 Speed Triple Drain Plug Broke Off Corner Of Pan

Triumph Motorcycle Forum - TriumphTalk

Help Support Triumph Motorcycle Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

369679

Member
What other model oil pans will fit an 06 Speed Triple? I can't justify a new $450 oil pan for a $2000 bike. I'm hoping all the 2006 1050 engines use the same pan.
 
I found a used Oil Pan Sump T1230202 on marketplace & ordered a new gasket for the 2006 speed triple 1050, it fits like a glove. I destroyed my original sump after turning it in the wrong direction cracking the the oil pan, after days scrapping off the old stuck on gasket with a pack of a 100 plastic razor blades.
I found an alternative Drain Plug instead of using a traditional drain plug, I used a Fumoto F106SX M14-1.5 Sx Series Drain Valve. So all I have to do is set a container under it, turn the lever and the oil will drain out, then turn it to close & fill the appropriate amount of engine oil. No more issues unless the seal needs to be replaced.
 
Last edited:
Then I would recommend copper crush washers as it handles heat & pressures the best & I use Valvoline as it protects against oil thickening & design for wet clutch as this bike requires.
 
I could keep a spare one under the seat that uses a 6mm allen hex to tighten the bolt. Also depending on how you install it, it would not get hit based on how you install it. The lever is spring loaded and locked into place and there's a plastic piece that sloted and snaps into please so the drain lever does not move whatsoever
 
Last edited:

Latest posts

Back
Top