Hello.
I'm looking for a solution how to connect heated 2. gen passenger seat with TEX 1. gen. On the TEX is front 1. gen heated seat with 6 pins connector and I don't know how to make splitter for 4 pins connector 2. gen passenger heated seat.
Any sugestion?
Best regards,
Zoran
Hi There.
I know I shouldn't answer without more specifics but... I was going to do the same this winter and put it off until next fall, unfortunately I can't find my notes. I was going to use a heated seat off a 2014 on my 2012. I did however figure out by looking at a 2014 Electrical schematic that some off the pins just aren't used. I was going to buy a harness of cheap seat heater with a switch and splice in the appropriate wires. I did find that connectors are available (in the UK). Retro fit xca heated seat to xcx I couldn't find them in the US.
So if you find a 2014 schematic you can figure out what 4 pins to hook up.
Hope this is more a help than a hindrance.
John
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
