Aftermarket Levers

[bigklar]

hello all just installed a set of aftermarket levers on my 2021 speed twin they are EVOTECH must say they are a work of art
well worth the money here in the uk the only problem i am having is on the brake lever its getting the plunger in the Brembo master cylinder it does not go into the rubber seal fully as the plunger is larger than the small hole in the seal i have tryed to lightly grease the plunger .the brake works fine but when you look at the rubber seal it is not seated fully any advice would be great
many thanks

 

[shanered6]

Have you tried taking the rubber dust seal off and fitting to the lever first , and then refit the lever then seal after .

 

[bigklar]

Have you tried taking the rubber dust seal off and fitting to the lever first , and then refit the lever then seal after .

no not yet afraid to just incase the seal does not go back into the master cylinder

 

[shanered6]

you could use a file and just taper the end of the pin a bit ?

 

[bigklar]

you could use a file and just taper the end of the pin a bit ?

my try this at the last resort i have changed countless aftermarket levers never has this problem before