Seeking Brake/tail Light Connector For Scram1200

[scr1200xc]

I'm putting some combination driving/brake/indicator lights on my scrambler 1200. I would like to do this without cutting into the factory wiring at all. I can do it easily with splicing and soldering, but I would like to avoid cutting any wires. I already have the round barrel connectors for the signal light outputs, not I just need the male and female parts for the tail/brake light plug. If I can get those I will will make my own adapter to wire in the new lights. Problem is that I don't know where to find this connector pair, and the code on the side of it is unreadable. Does anyone know where this connector can be purchased?

Thanks.

 

[Vector]

I do not but if there is an electrical supply shop near you show them the pic. Good luck.

 

[scr1200xc]

Figured it out. In case anyone else ends up looking for the same it looks like Triumph uses NAMZ NJST connectors (NJST-03P and NJST-03R on the 3 pin tail/brake; and NJST-02P and NJST-02R on the plate light).

 

[sikatri]

Did you find one local or did you order online?

 

[scr1200xc]

I had to order online. There aren't any shops near me that carry these types of connectors. It took quite a bit of searching through online electrical supply sites to figure out the right connector.