Diy Ignition Relocation To The Oem Instrument Panel

[Turp]

Martey, a member on another forum, demonstrated this mod could be done so after some planning I did my own.

It requires drilling a hole 1 1/8th inches and widening it out to 1.200 thousands with a sanding drum in a drill press. The ignition module is actually mounted on a .080 or 2mm aluminum plate that attaches using the instrument panel bolts. It's very straight forward but the biggest challenge is placing the ignition module mounting holes accurately.

 

[hemibee]

That's the type mods I like.

 

[DaveM]

Well done and how easy was the wiring side of this mod?

 

[Turp]

Thank you. No re-wiring is needed. There's enough attached wire to move the switch to the new location.

 

[DaveM]

Well that sure is a plus factor them.